DT 2-wire Manual de usuario descargar pdf (Pagina 16)

Setting

Item

L E D

state

Description Default

Door bell call tone 3-xx

Set the ring tone calling from door bell. Total 12

pieces ring tones can be selected(xx=01~12),press

Up button or Down button to increase/decrease

the value,settings will be performed immediately.

Ring volume 4-rx

Set the ring volume for call tone,range from 0~9.

Numbers of door

station

5-0x

Maximum 4 door stations can be selected,this

item is used to set the numbers of door station

that can be surveilled by indoor monitor. Refer to

part 2 ->Entrance Monitoring.

Numbers of

indoor monitor

6-xx

Maximum 32 indoor monitors can be selected,this

item is used to set the numbers of indoor monitor

that can be selected to intercom. Refer to part 2

->Intercom call.

Slave address

setting for monitor

7-dx

Rang from 0~3,"0"-master monitor,"1~3"-slave

monitor.

Restore to default

setting

8-FS

The restore to default function allows the user to

recover the settings to factory setting. Select "8-

FS" item on LED,then press Up button,"yES-

"will be asked,press Up button again,the LED

will be shown"SUCC",that means settings are

restored to default.

4. Specication

●

Power Supply: DC24V

●

Power Consumption: standby 25mA,working 110mA

●

7 segment LED: 4 digits dynamic

●

Wiring: 2 wires, non-polarity

●

Dimension: 187(H)X97(W)X33(D)mm

The design and specications can be changed without notice to the user. Right to interpret and copyright of this manual are preserved.

1 2 ... 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

DT 2-wire Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta DT 2-wire