DT 2-wire Especificaciones descargar pdf (Pagina 13)

DT  System  Technical Guide 10

+12V

LK - (GND)

LK+(COM)

N.O.

EB+

EB -

Remove the Jumper

set to Normally Open on the

Unlock Relay mode.(default)

DIPS-5: default set to off,

unlocking time is 1 second.

(In most cases, 1 second is

work for Power-to-Unlock type)

1 2 3 4 5 6

DIPS

JP_LK

+12V

LK - (GND)

LK+(COM)

N.O.

EB+

EB -

Remove the Jumper

set to Normally Closed on the

Unlock Relay mode on DT software.

DIPS-5: set to on,

unlocking time is 5 seconds.

1 2 3 4 5 6

DIPS

JP_LK

12V 300mA

Jumper set to 2-3 position

DIPS-5: set to on,

unlocking time is 5 seconds.

+12V

LK - (GND)

LK+(COM)

N.O.

EB+

EB -

1 2 3 4 5 6

DIPS

JP_LK

set to Normally Closed on the

Unlock Relay mode on DT software.

2. Additional power supply

When the electronic lock is over 12 Vdc, additional power supply for the lock is needed.

• The power supply for the lock must be less than 48Vdc 1.5A.

• The Jumper must be removed when using additional power supply. The default is set for PowertoUnlock

type(Normally open), if use PowerofftoUnlock type, change the Unlock Relay mode to Normally closed

on the Parameter tab of DT CONFIG software.

• If different unlocking time is needed to be congured, please use the DT CONFIG software to change the setting

on the Parameter tab(see the program section).

C. Connection for PowertoUnlock type:

B. Connection for PowerofftoUnlock type:

D. Connection for PowerofftoUnlock type:

Note:

Cut off this line when using

additional power supply

Note:

Cut off this line when using

additional power supply

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 52 53

Comentarios a estos manuales

Sin comentarios

DT 2-wire Especificaciones Pagina 13

Comentarios a estos manuales